Peak-system-technik PCAN-DONGLE IPEH-002019 Manual do Utilizador descarregar pdf (Página 8)

PCAN-Dongle (ISO) – User Manual

When using this option, the 5-Volt supply is directly connected to

the power supply of the PCAN-Dongle (coming from the PC) and is

not fused separately. The ISO version of the Dongle contains an

interconnected DC/DC converter. Therefore the current output is

limited to about 50 mA.

Attention! At this procedure a special care is indispensable

since there is a short circuit danger. The PCAN-Dongle could be

destroyed and/or the power supply or electronics of the PC or

other components connected could be damaged.

Important note: PEAK-System Technik GmbH does not give

guarantee on damages which have resulted from application of

the option described in this section.

Procedure:

1. In order to access the PCB, open the case of the PCAN-

Dongle by cautiously levering the latches on both sides (risk

of breakage!), e.g. with a flat tip screwdriver.

2. Set the solder bridges on the PCAN-Dongle PCB according

to the desired settings. Figure 2 and Figure 3 show the

possible positions of a solder bridge.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Sem comentários

Peak-system-technik PCAN-DONGLE IPEH-002019 Manual do Utilizador Página 8